after writing geometry, viewport focus's in on an approximately 1'x1' section of the model.

previous renders would show entire area as shown on sketchup screenlast 4 renders only picked a very small area and rendered (small area of fence/small area of stucco) doesen't seem to be the number of passes, I let it run 4000+ passes overnight and it didn't change the size. is this a setting or selection issue?

working in irender / su 2015 / win 7 pro / e5-1620 / 32 gb / 2- firepro w5000 /

Views: 85

Attachments:

Reply to This

Replies to This Discussion

I remember seeing a problem before where we had to toggle the camera between Perspective and Parallel Projection and then toggle it back again, to make SketchUp recalculate the camera position. You might try that and see if it fixes it.

Otherwise, if you can send us the model, we can try it here and see if we can figure it out.

Reply to Discussion

RSS

About

Render Plus created this Ning Network.

Search


Enter a phrase here to search the entire Render Plus web site:

Loading

Translate

Latest Activity

Rudi Schwarz posted photos
Mar 11
Chi Lau posted photos
Mar 5
Marilyn West commented on Marilyn West's photo
Feb 28
Marilyn West posted photos
Feb 28

© 2024   Created by Render Plus.   Powered by

Badges  |  Report an Issue  |  Terms of Service