I am trying to render a section cut of a building, so the interior lighting and exterior daylighting are both important. I am playing with Ariel Vision and having some difficulty getting the interior to render bright enough. Does anyone have any experience with this or setting recommendations?

Views: 188

Attachments:

Reply to This

Replies to This Discussion

Hi Serina

I use IrenderNXT so not sure if the following also applies to ariel vision.

Set up your scene and place your interior lights in specific channels (i use between 5 and 7)

Set up your section plane and do a render.

After the render is complete open the Lighting Channels Dialogue

(there is a tutorial on the site explaining its use.)

Using this you can adjust the levels of the lights in the interior.

You use the Sun and Sky settings to adjust the level of the exterior lighting (these are the first two channels in the Lighting Dialogue.)

This gives you full control over the relative brightness of the interior and exterior lighting.

Hope this helps

Regards

Mike  (Mesh-3D)

Reply to Discussion

RSS

About

Render Plus created this Ning Network.

Search


Enter a phrase here to search the entire Render Plus web site:

Loading

Translate

Latest Activity

Rudi Schwarz posted photos
Mar 11
Chi Lau posted photos
Mar 5
Marilyn West commented on Marilyn West's photo
Feb 28
Marilyn West posted photos
Feb 28

© 2024   Created by Render Plus.   Powered by

Badges  |  Report an Issue  |  Terms of Service