Only subcomponents in report

Replies to This Discussion

Permalink Reply by Render Plus on April 29, 2011 at 11:06am

 

You need to mark all your top level components as packages. They need to have an attribute which is marked "Skip_if". The logic below is a little more complex than that - it only drills into packages and does not drill into other components.

 

See: Package Components

Specifying Package Components

You can use similar logic to specify Package components, which should be drilled, but not shown on the report.

• Create a new attribute - Package - and set it to true for those items which should be drilled, but not reported.
• Create a new attribute - NoDrill - mark it as No_Drill, and set is to calculate as: !%Package%
  (NoDrill will be true for all components for which Package is false) (You only need to do this if you do not want to drill further into the sub-components)
• Mark Package as Skip_If. Components with Package set to true will be drilled into, and not shown on the report.

 

Attribute	Skip_if	No_Drill	Calculation
Package	set	not set
NoDrill	not set	set	!%Package%
others	not set	not set

• ▶ Reply

▶ Reply to Discussion