Problem with one material

Replies to This Discussion

Permalink Reply by Rich Hart on February 9, 2011 at 10:20am

It's probably a face in a group that has been mirrored, so the group is placed at a negative scale and we are using the material on the wrong side of the face. This is something we would need to trace down and fix in the software.

Until we trace it down and get it fixed, if you can drill down and edit the faces so that the same material is on both the front and reverse sides of the face, you should be able to fix it without exploding everything.

• ▶ Reply

Permalink Reply by Rich Hart on February 9, 2011 at 10:25am

Can you send me the model, so I can trace down the problem?

• ▶ Reply

Permalink Reply by Patrick Reynolds on February 9, 2011 at 11:12am

You diagnostic skills are impeccable!  It is mirrored, I'll follow your suggestion, and give it a go.

 

Thank you!

• ▶ Reply

Permalink Reply by Rich Hart on February 9, 2011 at 11:23am

Still, if you could send me the model, or just the front piece, I could see if it's something we can fix.

Patrick Reynolds said:

You diagnostic skills are impeccable!  It is mirrored, I'll follow your suggestion, and give it a go.

 

Thank you!

• ▶ Reply

▶ Reply to Discussion