Space Design Installation LF07 and LF08 - Report Layout and Anchors

Replies to This Discussion

Permalink Reply by Rich Hart on June 9, 2012 at 9:06am

Can you  be more specific here?

In the PDF the image has no size, is that what you're referring to? Or is there something else?

And does the small image occur for you with all reports, or is it just for the one you attached?

• ▶ Reply

Permalink Reply by GTM on June 9, 2012 at 9:13am

Dear Rich,

I have to rephrase that - when you use the anchors the preview with image 'ON' is fine (as above), but when you print to PDF you are getting something else - small image.

Regards

Gregory

• ▶ Reply

Permalink Reply by Rich Hart on June 9, 2012 at 5:50pm

The drag handle below the image just doesn't work right when working in mm, it sets the value on the dialog as if it was in inches, and then that small value gets used for the image height.

I'll fix that and post a new one ASAP. Meanwhile, just use the SketchUp Image Height dialog box, shown when you select "Images" on that tab, to set the image height correctly.

• ▶ Reply

Permalink Reply by GTM on June 9, 2012 at 7:03pm

Dear Rich,

Are you still in front of your computer ? Like me... 2.03 am in the UK. (I know is GMT-7 your time)

Thank you for the info.

PS. I have the habits of software troubleshooting from my first employment.

Regards

Gregory

• ▶ Reply

Permalink Reply by Rich Hart on June 9, 2012 at 11:31pm

I just had to figure out what was wrong...I suspected the metric/imperial thing that always needs more testing and had to see if that was it.

GTM said:

Dear Rich,

Are you still in front of your computer ? Like me... 2.03 am in the UK. (I know is GMT-7 your time)

Thank you for the info.

PS. I have the habits of software troubleshooting from my first employment.

Regards

Gregory

• ▶ Reply

Permalink Reply by Rich Hart on June 12, 2012 at 4:16pm

This is fixed in the latest release.

• ▶ Reply

▶ Reply to Discussion