nXtPlantEditor.exe has stopped working

Replies to This Discussion

Permalink Reply by Rich Hart on December 23, 2015 at 5:43pm

You're getting there by clicking on the leaf on the IRender nXt toolbar, Right?

• ▶ Reply

Permalink Reply by Dragan Stanojevic on December 24, 2015 at 12:25am

Yes.

• ▶ Reply

Permalink Reply by Rich Hart on December 26, 2015 at 12:27pm

If you double click, in File Explorer, on either of these two executable files, do you get an error?  Or do they run?

• ▶ Reply

Permalink Reply by Dragan Stanojevic on December 26, 2015 at 11:48pm

I get the same "nXtPlantEditor(64).exe has stopped working" message.

• ▶ Reply

Permalink Reply by Rich Hart on December 28, 2015 at 7:57am

Perhaps one of the DLLs that we run during the installation did not run successfully.

Could you right click on each of the executables in this folder and select Run as administrator for each, to see if there are any errors when they run?

C:\Program Files (x86)\Render Plus Systems\IRender_nXt\redist

Also, try running the file dotnetfx35_setup.exe, to make sure that that is installed..

• ▶ Reply

Permalink Reply by Dragan Stanojevic on December 28, 2015 at 8:10am

Success! Couple of them needed repair and now TreeMaker works.

Thank you Rich very much for support and great software.

Kind regards,

Dragan

• ▶ Reply

Permalink Reply by Rich Hart on December 28, 2015 at 8:21am

Great!

Thanks for the update,

Rich

• ▶ Reply

▶ Reply to Discussion