viewport problem

after writing geometry, viewport focus's in on an approximately 1'x1' section of the model.

previous renders would show entire area as shown on sketchup screenlast 4 renders only picked a very small area and rendered (small area of fence/small area of stucco) doesen't seem to be the number of passes, I let it run 4000+ passes overnight and it didn't change the size. is this a setting or selection issue?

working in irender / su 2015 / win 7 pro / e5-1620 / 32 gb / 2- firepro w5000 /

Attachments:

Capture.JPG, 152 KB

▶ Reply to This

Replies to This Discussion

Permalink Reply by Rich Hart on November 24, 2014 at 3:03pm

I remember seeing a problem before where we had to toggle the camera between Perspective and Parallel Projection and then toggle it back again, to make SketchUp recalculate the camera position. You might try that and see if it fixes it.

Otherwise, if you can send us the model, we can try it here and see if we can figure it out.